Made in high strength aluminum alloy drop profile 20×10 mm

Weight less than 1,45 Kg

IT IS NOT A COMPLETE FRAME 

Assembly Instruction

The conical countersink visible in the instructions is not part of the replacement, if you need it, order this item.

mounting of the 2-part 140cm cage on the Miniplane Classic chassis

From the bottom side drill 4mm, than rivet the hooks oriented as on the picture

remove the tank before drilling, to avoid damage if the drill bit slips

 

 

	to mount  the 4 fittings with 6 mm internal thread, use the 12,4 mm diameter 90° countersink,
	to make an housing 4mm deep
	You may need to gently clean the inside thread on the frame with a 10mm tap
	than use a 6Ma screw with a nut.
	to screw the fitting until it locks.
	To release the screw from the fitting, unscrew the nut slightly while holding the screw still, then you can remove the screw.